Hi,
I am trying to bring up gigabit interface in couple of Nexcom blade servers
running FreeBSD/amd64. The interfaces (two Marvell Yukon 88E8062 controllers)
are recognized properly, but no media is ever detected:
> ifconfig
msk0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=11a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4>
ether 00:10:f3:0d:d6:45
media: Ethernet autoselect (none)
status: no carrier
msk1: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=11a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4>
ether 00:10:f3:0d:d6:46
media: Ethernet autoselect (none)
status: no carrier
I tried manual setting of media - but the driver won't allow me to set
1000baseSX link (this is what other blades in the same chasis with working em
driver are reporting).
# ifconfig msk0 media 1000baseSX
ifconfig: SIOCSIFMEDIA (media): Device not configured
I'm puzzled here: are there known limitations in the driver wrt support of
certain media types?
Here is pciconf -lv information if it helps...
[EMAIL PROTECTED]:3:0:0: class=0x020000 card=0x628211ab chip=0x434711ab
rev=0x14 hdr=0x00
vendor = 'Marvell Semiconductor (Was: Galileo Technology Ltd)'
device = 'Yukon 88E8062 PCI-E IPMI Gigabit Ethernet Controller'
class = network
subclass = ethernet
This is on 7.0-RELEASE on amd64. I also tried kernel from 7-STABLE from few
days ago, but the problem was still present.
--
Best regards,
Krzysztof Jedruczyk
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
