Ok, I am not getting this to work after numerous tries and am feeling frustrated and ignorant.
$ cvs -d :pserver:[EMAIL PROTECTED]:/source login $ cvs -d :pserver:[EMAIL PROTECTED]:/source co -r release_1_0 radiusd Is it correct to say that after I successfully execute the 2 commands above that I should have a set of code that I need to compile with configure, make, and make install? When I attempt this, I get a set of files but am not successful at compiling them. Thanks and I appreciate your patience or advice you can give. -will -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Alan DeKok Sent: Thursday, July 28, 2005 5:23 PM To: FreeRadius users mailing list Subject: Re: newbie questions using freeradius as wifi access point "Will Carter" <[EMAIL PROTECTED]> wrote: > Am I correct to think that if I install one of the nightly builds that is > after the 1.0.4, then this issue should be addressed. I actually tried to > install the 07282005 snapshot but it wouldn't compile. Hmm... that's not good. Anyways, the latest snapshots change a *lot* more than you need. I suggest doing a "cvs checkout" yourself: $ cvs -d :pserver:[EMAIL PROTECTED]:/source login <blah> $ cvs -d :pserver:[EMAIL PROTECTED]:/source co -r release_1_0 radiusd Should get you 1.0.4 with a few fixes. Alan DeKok. - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html