Hi there..
We have an existing FreeRadius setup that works perfectly for our Cisco BRAS devices etc. I am trying to get some Juniper MX working properly. If I add a user to our system it works fine (dynamic IP assignment etc). The minute we add a static IP address, things go weird with the MX platform. The user authenticates and obtains the correct IP address but no traffic will pass. JTAC says this is an attributes related issue and we are back and forth. I was hoping someone on the list here could correct by users entry below based on their experiences? I'm running a fairly bare set of attributes hoping to figure out why this keeps breaking on the Juniper side: pstewart Auth-Type = System Service-Type = Framed, Framed-Protocol = PPP, Framed-IP-Address = xxx.xxx.111.73 Our typical users entry that works fine in the Cisco world looks like this: pso Auth-Type = System Service-Type = Framed-User, Framed-IP-Address = xx.xxx.58.115, Framed-MTU = 1500, Idle-Timeout = 11116000 So far I have messed around with many variables and not getting it to work properly.. At the same time JTAC has been quite helpful but we're still not operational yet. Thanks, Paul
- List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html