Dear freesurfer experts, I have encountered problems running recon-all on some subjects where the processes were stuck at "CORRECTING DEFECT 5 (vertices=14049, convex hull=3020) XL defect detected...".
I have read from the mailing list that this is a large defect to be manually corrected or control points. So does that mean the recon-all cannot correct this? If that is the case, what are the steps for manual correction or control points and how should I re-run the recon-all afterwards with incorporation of this correction? Regards, Jacky Lee
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.