Hi Eric, Instructions for building the sm1000 firmware in codec2-dev/stm32/README.txt
We use gcc/Makefiles rather than an IDE. Cheers, David On 22/08/16 20:09, [email protected] wrote: > Firstly Hi to every one on the forum. > > I’ve recently redesigned the SM1000 hardware so that I can fit the PCB > into a speaker mic. (or inside my FT-817) > That was the easy part, really! > > The hardware now uses an equivalent 64pin STM32 device and so needs a > few pins reassigned. > > This requires I rebuild the source code unfortunately I have had no success. > If any body has done this on a Windows machine I would like to as for > some guidance. > > What free IDE did you use? > Where did you out the libraries? > Any special configurations to generate the binary? > > I currently have the Eclipse STM32 IDE and the Atollic IDE installed > with the GCC compiler. > > The hardware comes up and connects in USB boot loader mode and the > analogue parts seem to work ok so now I just need to get the firmware to > build. > > Any help would be appreciated. > > Cheers > Eric > VK5KBB > > > > ------------------------------------------------------------------------------ > > > > _______________________________________________ > Freetel-codec2 mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/freetel-codec2 > ------------------------------------------------------------------------------ _______________________________________________ Freetel-codec2 mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/freetel-codec2
