Nice work Jeroen :-) We've just merged the data mode PR and have a README here:
https://github.com/drowe67/codec2/blob/master/README_data.md Thanks also jimt for proofing and correcting the README :-) Thanks, David On 28/5/20 8:11 am, Jeroen Vreeken wrote: > Of course my exprimental 6000 mode has also been updated to the new API. > And since yesterday the local 70cm repeater (PI2EHV) now accepts it as well. > Receiving is going realy well, transmitting is a special story.... > > Since it is still primarily used as an analog voice repeater, voice will > always be transmitted as regular analog FM. > As we use CTCSS on the transmitter it is possible to send 'other stuff' > without CTCSS and it won't bother the analog users. > (This is also done with the morse code identification it sends every 5 > minutes) > So any data packets will be transmitted in mode 6000. At the moment it > is just FPRS position (always the same :) and status reports, but it is > a start. > > So far the good news, than the bad: The DR-1X also seems to have > pre-emphasis on its tone input.... So I am only getting junk when trying > to demod it.... > A new challenge for tomorow... (maybe pre-de-emphasis will work...) > > 73, > Jeroen PE1RXQ > > p.s. Since PI2EHV is now doing mode 6000, did the world just lose its > only mode 2400B repeater? Or is anyone else using it? > > On 05/24/2020 12:02 AM, David Rowe wrote: >> As a starting point, I've been working with Jeroen to refactor and >> document not one but two (!) two data APIs: >> >> https://github.com/drowe67/codec2/blob/dr-data-demo/README_data.md >> >> > > > > _______________________________________________ > Freetel-codec2 mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/freetel-codec2 > _______________________________________________ Freetel-codec2 mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/freetel-codec2
