Good morning, ok, now I can solve my problem. I replace bind.
Greetings On Sun, 1 Jul 2007 23:24:33 +0200, Waldemar Brodkorb <[EMAIL PROTECTED]> wrote: > Hi, > > the problem is the big image. If you use squashfs-overlay, you need > at least 5 flash bocks free space for the jffs2 data partition, > where the overlay data is kept permanently. This means on your > system, you need 5*64kb free space. 3.3 MB is to big. 3.0 is save, > 3.1 is nearly maximum. Check with df -h on the device. > Check the free space of the data partition. > > bye > Waldemar > > On Sun, 01 Jul 2007 at 18:39 +0200, [EMAIL PROTECTED] wrote: >> >> On Sun, 1 Jul 2007 18:23:52 +0200, Przemyslaw Kujawski >> <[EMAIL PROTECTED]> wrote: >> > On 17:24 Sun 01 Jul , [EMAIL PROTECTED] wrote: >> >> last night I have build a new freewrt image including bind for dns > for >> > my >> >> linksys router. I have installed the image with mtd and reboot my >> > router. >> >> After reboot I logged in and want to change the directory to /etc. >> > >> > I had the same problem on my WRT54GL some time ago. NVRAM erase was > the >> > solution in that case. >> > >> >> Hi Przemyslaw, >> >> thanks for advise. I will try it next weekend when I´m at home again > and >> report my attempt. >> >> Do wiedzienia >> >> _______________________________________________ >> freewrt-users mailing list >> [email protected] >> https://www.freewrt.org/lists/listinfo/freewrt-users > > -- > All embedded development kits suck. This one just sucks less. > http://www.freewrt.org _______________________________________________ freewrt-users mailing list [email protected] https://www.freewrt.org/lists/listinfo/freewrt-users
