Hello.

Je suis en train de configurer un Brocade VDX (gray market donc pas de support 
malheureusement).

Impossible de monter un LACP, en faite c'est assez bizarre, le Port-Channel 
monte bien mais impossible de no shut les membres (Qui sont des ports 10g mais 
avec des sfp copper 1g), exemple :

bcn-sws-3-1# show port-channel 1
 LACP Aggregator: Po 1
 Aggregator type: Standard
  Admin Key: 0001 - Oper Key 0001
  Partner System ID - 0x0000,00-00-00-00-00-00
  Partner Oper Key 0000
 Member ports:
   Link: Te 0/35 (0x18118184) sync: 0
   Link: Te 0/40 (0x18140189) sync: 0
   Link: Te 0/55 (0x181B8284) sync: 0
   Link: Te 0/60 (0x181E0289) sync: 0

bcn-sws-3-1# sh run int po 1
interface Port-channel 1
 speed 1000
 description Uplink to BCN-SWC-3-1
 switchport
 switchport mode trunk
 switchport trunk allowed vlan add 110-112
 switchport trunk tag native-vlan
 no shutdown
!

bcn-sws-3-1(config)# int te 0/35
bcn-sws-3-1(conf-if-te-0/35)# no shut
bcn-sws-3-1(conf-if-te-0/35)# end
bcn-sws-3-1# sh run int te 0/35
interface TenGigabitEthernet 0/35
 speed 1000
 description Uplink
 channel-group 1 mode active type standard
 lacp timeout long
 shutdown # << wtf?
!


bcn-sws-3-1# sh int te 0/35
TenGigabitEthernet 0/35 is admin down, line protocol is down (admin down)
Hardware is Ethernet, address is 0005.334b.f97e
    Current address is 0005.334b.f97e
Pluggable media not present
Description: Uplink
Interface index (ifindex) is 403800452
MTU 2500 bytes
LineSpeed Actual     : Nil
LineSpeed Configured : 1000 Mbit, Duplex: Full
Priority Tag disable
IPv6 RA Guard disable
Last clearing of show interface counters: 03:39:48
Queueing strategy: fifo
Receive Statistics:
    0 packets, 0 bytes
    Unicasts: 0, Multicasts: 0, Broadcasts: 0
    64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0
    Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0
    Over 1518-byte pkts(Jumbo): 0
    Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0
    Errors: 0, Discards: 0
Transmit Statistics:
    1960 packets, 289098 bytes
    Unicasts: 8, Multicasts: 1302, Broadcasts: 650
    Underruns: 0
    Errors: 0, Discards: 0
Rate info (interval 299 seconds):
    Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
    Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:44:44


Le "Pluggable media not present" me porte a confusions vu que j'ai d'autre 
ports 10g qui sont up, fonctionnent bien mais qui retournent aussi ça, exemple:

bcn-sws-3-1# sh int te 0/1
TenGigabitEthernet 0/1 is up, line protocol is up (connected)
Hardware is Ethernet, address is 0005.334b.f95c
    Current address is 0005.334b.f95c
Pluggable media not present
Description: STORAGE
Interface index (ifindex) is 402685952
MTU 2500 bytes
LineSpeed Actual     : 10000 Mbit
LineSpeed Configured : Auto, Duplex: Full
Priority Tag disable
IPv6 RA Guard disable
Last clearing of show interface counters: 03:42:41
Queueing strategy: fifo
Receive Statistics:
    145608 packets, 29709612 bytes
    Unicasts: 144478, Multicasts: 940, Broadcasts: 190
    64-byte pkts: 112543, Over 64-byte pkts: 15686, Over 127-byte pkts: 2810
    Over 255-byte pkts: 730, Over 511-byte pkts: 613, Over 1023-byte pkts: 13226
    Over 1518-byte pkts(Jumbo): 0
    Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0
    Errors: 0, Discards: 0
Transmit Statistics:
    1176133 packets, 1658862747 bytes
    Unicasts: 1174922, Multicasts: 952, Broadcasts: 259
    Underruns: 0
    Errors: 0, Discards: 0
Rate info (interval 299 seconds):
    Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
    Output 0.000708 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 01:19:15

La version (Pas de support donc pas de MAJ malheureusement...): 

bcn-sws-3-1# show ver

Network Operating System Software
Network Operating System Version: 4.1.1
Copyright (c) 1995-2014 Brocade Communications Systems, Inc.
Firmware name:      4.1.1
Build Time:         19:48:22 Mar 19, 2014
Install Time:       12:34:44 Mar 23, 2015
Kernel:             2.6.34.6

BootProm:           2.2.0
Control Processor:  e500v2 with 2048 MB of memory

Appl     Primary/Secondary Versions
------------------------------------------
NOS      4.1.1
         4.1.1

Une idée?
Pas d'accès aux forums Brocade non plus sans support alors que la réponse y est 
surement...

Merci



---------------------------
Liste de diffusion du FRnOG
http://www.frnog.org/

Répondre à