I am running Check Point NG FP3 on Red Hat 7.3. I began to notice the following message:
fwlddist_adjust_buf: record too big for sync
From researching this on the Internet
(www.firewall-1.org/2002-11/msg00733.html) it appears that there might be a interface speed problem. I ran mii-tool to see the speed of my interfaces. I have 4 interfaces, 2 of them gave me an error since I guess the NICs do not support mii and the other two were set for auto and were at 100 FD, I checked the switch that I had recently replaced (which is why I think it may be the problem) and it was set for auto as well. Is there anyway to tell what interface this error message is refering to?
I have two questions:
1) Is this error message serious? Can I safely ignore it or is it something I should worry about? 2) Would you suggest forcing the NICs and the switch to 100 FD instead of auto?
Also the link I referenced suggests setting the speed and duplex using /etc/modules.conf, I am not familiar with that does anybody have a link that explains that in more detail.
Thanks!
_________________________________________________________________ Optimize your Internet experience to the max with the new MSN Premium Internet Software. http://click.atdmt.com/AVE/go/onm00200359ave/direct/01/
================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
