Hi, just install HFA318, that helps.
Best regards from sunny Vienna, Radu -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] Behalf Of Iv�n Vital Sent: Montag, 22. M�rz 2004 18:45 To: [EMAIL PROTECTED] Subject: [FW-1] fwlddist_adjust_buf record too big for sync Hi All: I've NG Feature Pack 3 Build 53920 After a little and beautiful stop and start of my Nokia's IP 350, i have the next message on the system log of one machine. "kernel: fwlddist_adjust_buf: record too big for sync" I've read Gus Fritschie mail and i think speed of siwitch or nics could be the the problem. �How can i adjust de speed of ninc on Nokia IP 350? Thanks. ----- Original Message ----- From: Gus Fritschie To: [EMAIL PROTECTED] Sent: Thursday, February 19, 2004 10:16 PM Subject: Re: [FW-1] AW: [FW-1] fwlddist_adjust_buf record too big for sync Thanks for all the help, I adjusted the speed and duplex on both the switch and the NIC to 100 FD instead of auto like I had and it did not make a difference. Then from looking at fw ver I realized I have not applied any HFAs. I will do this and see if it resolves the problem. Thanks! >From: "Steinecke, Sven" <[EMAIL PROTECTED]> >Reply-To: Mailing list for discussion of Firewall-1 ><[EMAIL PROTECTED]> >To: [EMAIL PROTECTED] >Subject: [FW-1] AW: [FW-1] fwlddist_adjust_buf record too big for sync >Date: Fri, 13 Feb 2004 09:34:57 +0100 > >Hi Gus, >in my experience it�s better to force the switch and the NIC to 100 FD. >This >adjustment fix some Problems on our IP350 and IP 330. > >Regards Sven > >-----Urspr�ngliche Nachricht----- >Von: Gus Fritschie [mailto:[EMAIL PROTECTED] >Gesendet: Mittwoch, 11. Februar 2004 19:26 >An: [EMAIL PROTECTED] >Betreff: [FW-1] fwlddist_adjust_buf record too big for sync > > >I am running Check Point NG FP3 on Red Hat 7.3. I began to notice the >following message: > >fwlddist_adjust_buf: record too big for sync > >From researching this on the Internet >(www.firewall-1.org/2002-11/msg00733.html) it appears that there might be a >interface speed problem. I ran mii-tool to see the speed of my interfaces. >I have 4 interfaces, 2 of them gave me an error since I guess the NICs do >not support mii and the other two were set for auto and were at 100 FD, I >checked the switch that I had recently replaced (which is why I think it >may >be the problem) and it was set for auto as well. Is there anyway to tell >what interface this error message is refering to? > >I have two questions: > >1) Is this error message serious? Can I safely ignore it or is it >something >I should worry about? >2) Would you suggest forcing the NICs and the switch to 100 FD instead of >auto? > >Also the link I referenced suggests setting the speed and duplex using >/etc/modules.conf, I am not familiar with that does anybody have a link >that >explains that in more detail. > >Thanks! > >_________________________________________________________________ >Optimize your Internet experience to the max with the new MSN Premium >Internet Software. http://click.atdmt.com/AVE/go/onm00200359ave/direct/01/ > >================================================= >To set vacation, Out-Of-Office, or away messages, >send an email to [EMAIL PROTECTED] >in the BODY of the email add: >set fw-1-mailinglist nomail >================================================= >To unsubscribe from this mailing list, >please see the instructions at >http://www.checkpoint.com/services/mailing.html >================================================= >If you have any questions on how to change your >subscription options, email >[EMAIL PROTECTED] >================================================= > >================================================= >To set vacation, Out-Of-Office, or away messages, >send an email to [EMAIL PROTECTED] >in the BODY of the email add: >set fw-1-mailinglist nomail >================================================= >To unsubscribe from this mailing list, >please see the instructions at >http://www.checkpoint.com/services/mailing.html >================================================= >If you have any questions on how to change your >subscription options, email >[EMAIL PROTECTED] >================================================= _________________________________________________________________ Stay informed on Election 2004 and the race to Super Tuesday. http://special.msn.com/msn/election2004.armx ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
