Check out 5.0.50. It fixed a bunch of VPN problems in 5.0.43 including a
memory leak that made me have to reboot mine every few days.
Ray
From: Russell Aspinwall <[EMAIL PROTECTED]>
Reply-To: Mailing list for discussion of Firewall-1
<[email protected]>
To: [email protected]
Subject: Re: [FW-1] VPN-1 Edge X Setup
Date: Wed, 16 Feb 2005 14:15:15 +0000
Hi,
I have used a variety of firmware versions on the Edge and found v5.0.43x a
vast improvement since
v4.0.93x and many in between. Site to Site VPNs offer a significantly
better level of performance
and reliability, primarily NGAI R55 to Edge, Edge to Edge VPNs have not
been a problem.
Stephen W. Stewart wrote:
Hi All,
Trying to set up an Edge X box for a remote office in Site to Site mode.
I currently have 2 other sites that are working just fine. The only
difference with the new X is that it will have a static IP and the two
that are working are using DHCP.
I can create the site and then look in the reports section at the VPN
Tunnels section and nothing shows up. If I ping the internal IP of the
X box a tunnel is established and the X box replies. I cannot ping the
other way into the "home" network behind the FW-1.
The established tunnel shows IKE (Phase 1): 3DES/SHA1.
Any ideas?
Thanks
Stephen W. Stewart
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
--
Regards
Russell
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
