Hi All,
I've configured a new ftp server to replace an existing ftp server. All
settings of both servers are the same (ip address, pc name, same number
of interfaces, etc).
Disconnected the cable from old server and connected to correct
interfaces on new server. Powered off old server. Powered the new
server. When I try to connect to new server, I could not establish an
ftp connection (it seems to hang). I check on tracker, it reports
address spoofing.
I've checked from CP KB that to make this to work is to disable on
Smartdefense the address spoofing. I do not want to disable this feature.
I thought that it was because I've powered too soon the new server
without waiting for the timeout to lapse (3600 sec (1 hour)).
Question, if I wait for the timeout to lapse, will the address spoofing
error go away (I can then make connection to new ftp server)? Or is
there another solution.
Please advise.
Thanks
Cezar
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
