Thank you very much to David and everyone. It was determined that the NIC has some serious issues as seen below:
JFK-Cisco-NG-2-S[admin]# tcsh JFK-Cisco-NG-2-S[admin]# ipsctl -a | grep linktrans ifphys:eth-s1p1:stats:linktransitions = 1 ifphys:eth-s1p2:stats:linktransitions = 5 ifphys:eth-s1p3:stats:linktransitions = 105421 ifphys:eth-s1p4:stats:linktransitions = 3 ifphys:eth-s2p1:stats:linktransitions = 16511 ifphys:eth-s2p2:stats:linktransitions = 0 ifphys:eth-s2p3:stats:linktransitions = 0 ifphys:eth-s2p4:stats:linktransitions = 7 ifphys:loop0:stats:linktransitions = 0 ifphys:soverf0:stats:linktransitions = 0 ifphys:stof0:stats:linktransitions = 0 ifphys:tun0:stats:linktransitions = 0 I am going to swap out the firewalls altogether. --- David DeSimone <[EMAIL PROTECTED]> wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > Hugo van der Kooij <[EMAIL PROTECTED]> wrote: > > > > Keep an eye on `netstat -ni` to see if errors are > increasing on 1 of the > > interfaces. > > For IPSO devices a useful command is: > > # ipsctl -a | grep linktransitions > > This will tell you how many times the link has > bounced on each port. > > One of our more flaky IP650's shows this: > > ifphys:eth-s2p1:stats:linktransitions = 23 > ifphys:eth-s2p2:stats:linktransitions = 245 > <<< not good > ifphys:eth-s2p3:stats:linktransitions = 13 > ifphys:eth-s2p4:stats:linktransitions = 5 > > This is our most typical failure on IP650's, the > quad nics start > generating link transitions, getting progressively > worse until the card > must be replaced. > > - -- > David DeSimone == Network Admin == [EMAIL PROTECTED] > "It took me fifteen years to discover that I had > no > talent for writing, but I couldn't give it up > because > by that time I was too famous. -- Robert > Benchley > -----BEGIN PGP SIGNATURE----- > Version: GnuPG v1.4.1 (GNU/Linux) > > iD8DBQFGQ2ShFSrKRjX5eCoRAiNXAJ9OwNKVCicT0hRDD1KYmEVGeZGjHACghDeQ > F0g3bNA3Nc4bsyEKqq4EsCA= > =AT9Y > -----END PGP SIGNATURE----- > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > ____________________________________________________________________________________ Bored stiff? Loosen up... Download and play hundreds of games for free on Yahoo! Games. http://games.yahoo.com/games/front ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
