What does not work is precisely adding a Secondary IP via sysconfig, what IS supported and works fine (I have it working with one of my customers), is creating VLANs on the interface you need to put more than one IP.
In my case I had IPs X and Y and so I created VLAN 3.2 and VLAN 3.3 on eth3 and assigned those IPs to each one of the VLANs. Smart View Monitor shows only the first VLAN IP and I believe some other CLI commands outputs were showing just the first IP, but the cluster works fine. On 8/6/07, Eric Appelboom <[EMAIL PROTECTED]> wrote: > > Checkpoint states that adding a secondary vip is not supported in > clusterxl #sk31821 below. > Has anybody got a unsupported way to get this to work? (splat R65) > > cphaprob -a if always only lists physical and vlan interfaces and only > one vip. > If I have a host on the network I can ping all the other virtuals I have > defined on other interfaces. (arp-replies) > For all the other vips\subnets I get no answer. > > Last Modified: 22-Apr-2007 > Symptoms > > * A secondary IP address that has been defined in sysconfig in > ClusterXL does not work. > > Cause > Secondary IP addresses are not supported in ClusterXL. > Solution > No fix is required, since the system is functioning as designed. > Applies To: > > * Secondary IP > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > -- Sergio Alvarez (506)8301342 ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
