Sergio, my problem is that I want these subnets to be part of one vlan and I do not wish to split subnets into a different vlan each.
In your example below you are creating two tagged vlan interfaces right? Eric On 8/6/07 5:58 PM, "Sergio Alvarez" <[EMAIL PROTECTED]> wrote: > What does not work is precisely adding a Secondary IP via sysconfig, what IS > supported and works fine (I have it working with one of my customers), is > creating VLANs on the interface you need to put more than one IP. > > In my case I had IPs X and Y and so I created VLAN 3.2 and VLAN 3.3 on eth3 > and assigned those IPs to each one of the VLANs. Smart View Monitor shows > only the first VLAN IP and I believe some other CLI commands outputs were > showing just the first IP, but the cluster works fine. > > On 8/6/07, Eric Appelboom <[EMAIL PROTECTED]> wrote: >> >> Checkpoint states that adding a secondary vip is not supported in >> clusterxl #sk31821 below. >> Has anybody got a unsupported way to get this to work? (splat R65) >> >> cphaprob -a if always only lists physical and vlan interfaces and only >> one vip. >> If I have a host on the network I can ping all the other virtuals I have >> defined on other interfaces. (arp-replies) >> For all the other vips\subnets I get no answer. >> >> Last Modified: 22-Apr-2007 >> Symptoms >> >> * A secondary IP address that has been defined in sysconfig in >> ClusterXL does not work. >> >> Cause >> Secondary IP addresses are not supported in ClusterXL. >> Solution >> No fix is required, since the system is functioning as designed. >> Applies To: >> >> * Secondary IP >> >> ================================================= >> To set vacation, Out-Of-Office, or away messages, >> send an email to [EMAIL PROTECTED] >> in the BODY of the email add: >> set fw-1-mailinglist nomail >> ================================================= >> To unsubscribe from this mailing list, >> please see the instructions at >> http://www.checkpoint.com/services/mailing.html >> ================================================= >> If you have any questions on how to change your >> subscription options, email >> [EMAIL PROTECTED] >> ================================================= >> > > ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
