Hi, I guess some of you run Checkpoint R65 on Crossbeam.
I got a problem when I tried to upgrade it from R65 HFA02 to R65 HFA30. The installation of HFA30 itself worked perfectly, but after i rebooted I got this: root$ cphaprob state Cluster Mode: Sync only (OPSEC)) Number Unique Address Firewall State (*) 2 (local) 192.168.xxx.xxx Down (during cluster upgrade) When I tried to fail over the cluster, so I could upgrade my primary gateway, the secondary gateway doesn't forward traffic. Everything else works. I see the secondary gateway gets the vrrp adresses and all that, but everything just stops. My primary node says: root$ cphaprob state Cluster Mode: Sync only (OPSEC)) Number Unique Address Firewall State (*) 1 (local) none Active 2 192.168.xxx.xxx Down Why it says none I don't know, but that happened after I upgraded XOS to 8.1.0-147 today. Anyone seen this before or know if this is the way its supposed to be? Regards, Torkel Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
