On Fri, Oct 24, 2008 at 6:03 AM, Torkel Mathisen <[EMAIL PROTECTED]>wrote:
> Hi, > > I guess some of you run Checkpoint R65 on Crossbeam. > > I got a problem when I tried to upgrade it from R65 HFA02 to R65 HFA30. > > The installation of HFA30 itself worked perfectly, but after i rebooted I > got this: > > root$ cphaprob state > > Cluster Mode: Sync only (OPSEC)) > > Number Unique Address Firewall State (*) > > 2 (local) 192.168.xxx.xxx Down (during cluster upgrade) > > When I tried to fail over the cluster, so I could upgrade my primary > gateway, the secondary gateway doesn't forward traffic. > > Everything else works. I see the secondary gateway gets the vrrp adresses > and all that, but everything just stops. > > My primary node says: > > root$ cphaprob state > > Cluster Mode: Sync only (OPSEC)) > > Number Unique Address Firewall State (*) > > 1 (local) none Active > 2 192.168.xxx.xxx Down > > Why it says none I don't know, but that happened after I upgraded XOS to > 8.1.0-147 today. > > Anyone seen this before or know if this is the way its supposed to be? > > Have you got the cluster control protocol in broadcast mode? -- ciao JT Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
