did you try to enable debug on the isprd (ie ipso routing daemon) ?

Nope...clues, please?

   do you try with or without fw running. ?

Both, no difference.

-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:[email protected]] On Behalf Of pkc_mls
Sent: 08 July 2009 20:07
To: [email protected]
Subject: Re: [FW-1] IPSO, zebra & OSPF

Stephen Jones a écrit :
>  
> Hi,
>   
hi
> Tryng to get IPSO talking to ospfd v2 in zebra.
>   
As far as I know, zebra has been replaced by quagga.
(but should work anyway :) )
>  
> However neither end of the link appears to get past the init state.
>   
did you try to enable debug on the isprd (ie ipso routing daemon) ?
do you try with or without fw running. ?
>  
> Had similar issues getting IPSO talking to Cisco but that was sorted 
> by turning off lls on the cisco device.
>  
> Anyone any ideas?
>  
> Thx
>  
> Stephen


Scanned by Check Point Total Security Gateway.

=================================================
To set vacation, Out-Of-Office, or away messages, send an email to
[email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your subscription options, email
[email protected]
=================================================




Scanned by Check Point Total Security Gateway.

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================

Reply via email to