Le 10/7/2010 11:17 PM, Bachmann, Olaf a écrit :
Hi.
Hallo,
I have trouble to setup DSL (pppoe) on SPLAT (open server). Does anyone
have a how-to for that? The CheckPoint KB isn't realy helpful. I've also
noticed the KB sk41750.
You create the interface via sysconfig or https admin.
Once it has been created, check with an ifconfig and netstat tha bot
interface and route are correct.
All I did is to create a new interfcace (pppoe) and assigned it to the
physical interface eth0 (Webadmin).
Because the pppoe0 interface will not import via topology import,
someone told me I should assign a virtual IP address to eth0. After the
"Import Interface with Topology" I should change the imported IP to the
static public ip which will assign via pppoe dialin.
You can create the pppoe0 interface manually in the topology. (at least
it works for my config here).
The SmartTracker shows outgoing traffic but without response (NAT-hide
rule is present).
create a network object for the public IP that comes with the pppoe, and
create a manual nat hide
to translate source IPs behind the pppoe public IP interface for outgoing.
check with fw monitor that the traffic is correctly translated.
Olaf
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
Scanned by Check Point Total Security Gateway.
