Le 10/11/2010 1:51 PM, Bachmann, Olaf a écrit :
Hello.
Hi,
PPPoE interface was created and ifconfig shows following information:
pppoe0 Link encap:Point-to-Point Protocol
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:138 errors:0 dropped:0 overruns:0 frame:0
TX packets:34 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:46067 (44.9 Kb) TX bytes:1966 (1.9 Kb)
you should mask your real IP addresses or replace them with fake ones.
keep in mind the miling list is archived.
I removed the "virtual IP adress" [192.168.1.1] I had assigned to the network
interface eth0 (used for pppoe). Then I made a update topology to remove eth0 with his
IP, created the pppoe0 interface manually and inserted the public IP which will assign by
pppoe dialn.
I created a network object for the public IP and a manual NAT rule with this to
hide all outgoing traffic behind this IP.
The strange thing is, ICMP works well (request, reply and I see translated
packages with iIoO) but dns (name resolution) doesn't work. I can't see
traslated outgoing packges (O) in the capture file, I made with 'fw monitor
-iIoO -o capture-file.cap'.
Check with "fw ctl zdebug drop" why the traffic is dropped.
Check in the tracker if your filetring and nat rules are correctly applied.
Best regard
Olaf
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
