I run NT, with 4 NICs, the only problem I've had, is that the first time I installed NT, it completely messed up the interface names, so that the shown IF-names were not the names actually assigned to the interfaces.
Cheers, Anders :) > -----Original Message----- > From: Linder, Gary W. [mailto:[EMAIL PROTECTED]] > Sent: 19. desember 2001 16:09 > To: [EMAIL PROTECTED] > Subject: [FW-1] Multiple NICs on NT > > > I am running FW-1 v4.1/sp5 on NT v4/sp6a+299444 with multiple > NICs. I have > ran successfully with three NICs but when I add the fourth > traffic from my > external addresses no longer is "passed"/NAT to the internal address. > > Has anyone successfully added 4 NICs to NT? > > Any help or suggestions would be appreciated. > > > > Gary > > Gary Linder > > Direct phone: (402) 563-5350 > E-mail: [EMAIL PROTECTED] > > ================================================= > To set vacation, Out Of Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
