Thanks Martin Hoz. I tipe fw stat partner_ip. Them HOST POLICY DATE Authentication for command stat failed Failed to get interface status on xxx.xxx.xxx.xxx: Unauthorized action
can i do putkey whitout lose relationship whit management console ???? -----Original Message----- From: Martin Hoz [mailto:[EMAIL PROTECTED]] Sent: Lunes, 04 de Febrero de 2002 11:38 To: [EMAIL PROTECTED] Subject: Re: [FW-1] High Availability "Andrade Guerra, Marcelo" wrote: > > Hi All, I have 2 IP330 whit vrrp , but when fail over occurs all conection > is droped. Where i can see the sincronization??? Assuming 4.1, since NG on Nokia is relatively new.... Try to watch the connections table as well as the sync configuration: Connections table: fw tab -t connections -s This could verify if sessions are being shared. SYNC config: cat $FWDIR/conf/sync.conf If the file does not exists, then create it. Take a look on the manual to verify specific options. You have to have established trust between modules (i.e. fw stat partner_IP_address) should work between them. If trust not established, they do "fw putkeys". HTH. Best regards. - Mart�n. -- Mart�n H. Hoz-Salvador EX-A-IEC, EX-A-FIME (UANL) http://gama.fime.uanl.mx/~mhoz "Somos consecuencia del pasado, y causa de nuestro futuro." "Este mundo no nos ha sido legado por nuestros padres, sino lo hemos recibido prestado por nuestros hijos..." ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
