When you say it is not working, I am assuming rest of the firewall dmz's are
working but only the one with the changed card is not working. If the
firewall is connected to a switch, pl. flush the arp cache(on cisco this
would be clear arp-cache at the enable prompt). Check the devices on that
segment/dmz for arp entries and verify that it matches with the new mac
address. Alternatively, if your fw is running off a sparc, you can overwrite
the new mac with the original mac address(ifconfig command). I also am
assuming that this card is functional and you can see that the link led is
glowing.
hope this helps.
-----Original Message-----
From: Sridhar Gupta [mailto:[EMAIL PROTECTED]]
Sent: 03 October 2000 12:52
To: [EMAIL PROTECTED]
Subject: [FW1] Problem after changing Ethernet card
Hi Everybody,
I am facing following problem,
My firewall was running fine. I want to change on of the Ethernet card
connected to the system. I canged it. Suprisingly Firewall functionality is
not working. Then I brought back the old card and inserted it. It started
working.
After changing the card Installed the correct driver.
Is there any where MAC address is written to FW.
Please suggest me the solution.
Thanks in Advance.
gupta.
_________________________________________________
Get Your Free Email At, http://www.rediffmail.com
For fabulous shopping deals visit:
http://www.rediff.co.in/shopping/index.html
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
