Dear Listers
I seem to have been a bit unlucky when buying a Pismo on eBay. I hope
you don't mind the following shaggy dog story.
Firstly the DVD drive died within hours of receipt of the wee beauty.
I bought a replacement mechanism but I can't put it in the dead
drive's housing because I can't undo two of the screws. However, I
was given an intact 24X CD-R drive and so I can put the DVD drive
into its housing. This seems a waste. DOes anyone think I can drill
the stuck screw out without damaging the housing beyond use?
Next the power cable died. Replacement was easy and cheap, so I got
as far as installing and configuring OSX, classic and other software.
During a visit to England the power cables stopped delivering power
to the Pismo. I was able to keep it charged using my mum's clamshell
iBook cables. However, I then used it quite a lot, such that there
was maybe 15 minutes left on the battery. Thinking that if the power
cable was new then the fault must be in the yo-yo (the old one had
had issues) I bought a brand-new one.
By the time it arrived, I'd also received a bigger HD and so had
installed that, following the Apple Service Manual's take-apart
methods. I did have some trouble taking out the processor card
because the wee plastic tag you have to pull on to extract this had
torn before I received the Pismo. In the end, I used a pair of
needle-nosed pliers to grasp the remnant of the tag and pull it up.
I also put a 512MB RAM card that had been in the upper slot in the
lower slot and put the 128MB card that had been in the lower slot
into the upper slot (to make it easier to replace this when I can
afford more RAM).
I'm pretty sure that I reassembled everything properly. (It's
possible that I didn't seat the processor card properly when I first
reassembled it.) However, I can't start the Pismo using either the
old nor the new yo-yo. The battery is completely flat but so long as
the power cables are delivering power, should this matter?
I can think of the following possible reasons for it not starting up
* I've damaged the processor card
* I've damaged the I/O logic board it connects to
* when taking out or replacing the hard drive assembly, I've damaged
the inverter board or soundcard (which also appears to be where the
power switch is connected. I can't see any damaged cables and I'm
loath to try to take it apart further to investigate.)
* the power port has been damaged by dodgy power cables.
* I've damaged the hard drive cable
I know both of the old hard disk and the new hard disk are OK - when
put into a USB enclosure, they mount on my G4/400 desktop.
Any thoughts on how I can diagnose the fault(s) or should I go to my
nearest Apple Service provider?
thanks in advance
Bruce Ryan
--
--
immobile Bruce - laptop is toast, will stay in front of G4
--
G-Books is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished
Drives |
-- Check our web site for refurbished PowerBooks | & CDRWs on
Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
G-Books list info: <http://lowendmac.com/lists/g-books.html>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:G-Books@mail.maclaunch.com>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/g-books%40mail.maclaunch.com/>
---------------------------------------------------------------
iPod Accessories for Less
at 1-800-iPOD.COM
Fast Delivery, Low Price, Good Deal
www.1800ipod.com
---------------------------------------------------------------
