Jean-Marc Lasgouttes wrote:
>
> >>>>> "Jean-Marc" == Jean-Marc Lasgouttes <[EMAIL PROTECTED]> writes:
>
> >>>>> "Garst" == Garst R Reese <[EMAIL PROTECTED]> writes:
> Garst> The following should make it obvious
>
> Garst> bash$ ls -l /usr/local/bin/bin
>
> Jean-Marc> Did you run "make distclean"? What is the output of your
> Jean-Marc> configure run?
>
> running ./autogen.sh may be useful too.
>
> JMarc
I did both when there were lots of files changed, then did another
update where only a few files changed and just did a make. I think the
only change between the two was your half-fix to the compile problem.
Attached what I hope is all of the relevant output from configure.
Thanks, Garst
checking whether make sets ${MAKE}... yes
checking for prefix by checking for reLyX... /usr/local/bin/reLyX
checking for a BSD compatible install... /usr/bin/ginstall -c
checking for perl >= 5.002... /usr/bin/perl
configure: creating ./config.status
config.status: creating Makefile
config.status: creating reLyX
config.status: creating noweb2lyx
Configuration
Host type:
Special build flags: warnings assertions included-libsigc use-pspell
C Compiler: gcc
C Compiler flags: -O2
C++ Compiler: g++ (3.0.2)
C++ Compiler flags: -O -W -Wall
Linker flags:
Frontend: xforms
libXpm version: 4.11
libforms version: 0.89.5
LyX binary dir: /usr/local/bin
LyX files dir: /usr/local/share/lyx
Configuration of LyX was successful.
Type 'make' to compile the program,
and then 'make install' to install it.
