Has anyone managed to get a VPN tunnel working between a Linksys BEFSX41 and a GB-1000?
The GB-1000 has a static address and the Linksys is dynamic. I have tried to configure the systems as per the static to dynamic gateway document, but without any luck When I try to create a tunnel based on the current IP address of the BEFSX41 and the GB-1000 (ie as per static to static arrangement) the BEFSX41 locks up and you need to cycle the power to get it going again.... Any hints/tips etc would be most appreciated. (Note: There are sufficient licenses on the GB-1000 to cater for this tunnel) Regards, Hamish Cant BATES SMART www.batessmart.com.au Important Notice. Privileged/Confidential Information may be contained in this message. If you are not the addressee indicated in this message (or responsible for delivery of the message to such person) you may not copy or deliver this message to anyone. In such case you should destroy this message and kindly notify the sender by reply email. Opinions, conclusions and other information in this message that do not relate to the official business of Bates Smart shall be understood as neither given or endorsed by it. In no event shall Bates Smart, its employees, contractors or any associates be liable for specific, indirect, or consequential damage or loss arising from negligence or otherwise, which may occur through transmission of the message and attachments. --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] To subscribe to the digest version first unsubscribe, then e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Archive of the last 1000 messages: http://www.mail-archive.com/[EMAIL PROTECTED]
