Hi. Using OGR, I'm trying to reproject a DXF file. I'm using ogr2ogr, but I get two type of errors depending if I start with a BIN DXF or an ASCII DXF file.
With BIN DXF: ogr2ogr -s_srs 27492.prj -t_srs 4326.prj myfile_WGS84.dxf myfile_BIN12.dxf I get this error message: FAILURE: Unable to open datasource `myfile_BIN12.dxf' with the following drivers. [+ the list of installed drivers, included DXF] With ASCII DXF ogr2ogr -s_srs 27492.prj -t_srs 4326.prj myfile_WGS84.dxf myfile_ASCII12.dxf I get this error message: FAILED: Layer entities already exists, and -append not specified. Consider using -append, or -overwrite. ERROR 1: Terminating translation prematurely after failed translation of layer entities (use -skipfailures to skip errors) (effectively, 'entities' does exist, but this the expected situation, right?) I don't know what I am doing wrong. I tried with different BIN and ASCII versions (R13, R14, 2007, 2010), with the same errors. Thank you very much in advance. _______________________________________________ gdal-dev mailing list gdal-dev@lists.osgeo.org http://lists.osgeo.org/mailman/listinfo/gdal-dev