On 12/22/06, Tuck Hartshorn <[EMAIL PROTECTED]> wrote:
Yes, this was on also. I did one more manual route after I cleaned under my pads, before everything disappeared and I still could not complete. So, once I get my nets back, I will do this one more time with "enforce" off.
Press the "o" key to optimize the nets. If the "rat lines" layer is enabled you should be able to see the rats line. I usually leave the "auto enforce DRC clearance" on as well as the "Crosshair shows DRC clearance". Keeping these on can prevent quite a few errors. I would also suggest running the "Design Rule Checker" *OFTEN*. It is much easier to fix these problems as you go along rather than ending up with a large list of problems after the "Congratulations!!" message. (* jcl *) -- http://www.luciani.org _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user