Am Sonntag, den 05.10.2008, 00:09 +0100 schrieb Peter Clifton: > On Sat, 2008-10-04 at 10:22 -0400, DJ Delorie wrote: > > > Is there something similar for copper clearing of pads/pins in polygons? > > > > Not that I'm aware of. Again, you could write one pretty easily by > > copying the existing one. > > changeclearsize(selected,10,mil) > > Also works for mask, if you select the mask layer before running it. >
A late response... For mask changeclearsize() seems not to act on distance of mask relief to copper but on total relief size. So changeclearsize(selected,8,mil) will not make the relief 8 mil larger than pad (as desired by me) For copper clearance changeclearsize() works fine. To adjust mask DJ's solution seems to work perfect: DJ Delorie wrote on 4 Oct 2008: >There is a MinMaskGap() action to increase the mask gap to vendor >minimums. What you can do is this: >* Enable the mask layer >* Select everything that needs the mask set >* Use Ctrl-Shift-K to reduce the mask as much as you can for everything selected >* :MinMaskGap(Selected,=8,mil) to increase them all to that amount _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user