Hi DJ,
On Thu, 2008-11-20 at 00:55 -0500, DJ Delorie wrote: > > I can't repro the MM line garbage. I downloaded bx.pcb and while > > there is a single point line IN the file (out in space) I can't get > > points by deleting any of the lines already in the file or by > > drawing some in the grid saved with the file and then deleting them. > > I can. Set a 0.25mm grid and draw a bunch of lines that *look* like > plain 45 lines (i.e. no obvious corner, like you'd often get with _/, > and don't use X). About one in four will produce a 1/100 mil line to > compensate for the grid rounding. > > Heck, just drawing a diamond between the four grid points surrounding > a fifth is enough to get two remnants. > I just did, 10 times :) Results 9 times 2 out of 4, and 1 time 3 out of 4 possible garbage lines emerged. Maybe it's even possible to get 5 garbage lines for 4 traces drawn. I'm not that good with statistics. All 21 garbage lines have a *horizontal* length of 0.01 a mil. Bad luck ? I think not :) Would be fairly easy to write a plug-in to clean up on the garbage side of the "mm garbage" problem, this doesn't solve things on the "root cause" side of the "mm garbage" problem. Or is it a "mil garbage" problem ? Kind regards, Bert Timmerman. > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user