Hi Chris, Welcome to the free world!
If you've not already found it, a good place to start is here: http://geda.seul.org/wiki/geda:gsch2pcb_tutorial then have a good read of: http://geda.seul.org/wiki/geda:gschem_symbol_creation and http://geda.seul.org/wiki/geda:transistor_guide Then have a look at this bit of the FAQ here: http://geda.seul.org/wiki/geda:faq-gschem#gschem_symbols I only suggest doing it that way round because otherwise you may get distracted by the rest of the FAQ ... and when it comes to PCB footprints, I'd recommend you read this first: http://www.brorson.com/gEDA/land_patterns_20070818.odf or http://www.brorson.com/gEDA/land_patterns_20070818.pdf from: http://www.brorson.com/gEDA/ and then go back to: "FAQs & Quick Reference" http://geda.seul.org/wiki/ :) Cheers, Andy. Signality Solutions t: +44 (0) 5601 720 580 m: +44 (0) 7796 538 192 skype: andyfierman www.signality.co.uk On 2 February 2010 13:32, Chris Cole <cle...@gmail.com> wrote: > Hey all, > I'm new to the gEDA community (and fairly new to electronics in > general), and I have a pretty simple question for the gurus. I was > working on converting a PIC project schematic into gschem when I > realized that none of the Microchip IC's I was using were in the > component library. What's the standard procedure for this? Is it easier > to mooch off an existing part or to create your own? > Thanks, > Chris > > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user