Am 18.01.2011 um 01:56 schrieb John Griessen:
I thought about this some more after sleeping last night, and what
Markus
is probably asking for is a position range sensitive diff or auto-
merge.
When people make changes in PCB that can be merged, it means they are
working in different places, zones, quadrants... IOW if you could
say easily *where* you were working was different and not overlapping
another's work, an auto-merge would work -- if it only over-rode
layout
traces and footprints in the limited zone of the change made...
That reminds me on an idea discussed here a few weeks ago: drop the
current footprint logic and replace it with full fledged circuit
layouts. You'd edit the sub-layout in it's own file and insert that
into the total layout as a non-editable, but movable block.
One possible drawback for both ideas: you can't route tracks through
the "foreign" area/sub-layout, even if there's enough room after
assembling the zones.
Markus
- - - - - - - - - - - - - - - - - - -
Dipl. Ing. (FH) Markus Hitter
http://www.jump-ing.de/
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user