On Wed, Feb 23, 2011 at 2:38 PM, yamazakir2 <yamazak...@gmail.com> wrote: > After you get done soldering and fluxing up your board to solder a lot > of SMT components, what do you guys use to get it looking flux-free > and clean again? I tried MG Chemical flux remove and while it does > remove the flux, after washing it (with tap water) and drying it, it > leaves a nasty well-ish film on the board that make it actually look > worse.
Water soluble flux, hot running water and an acid brush with the bristles cut short. (* jcl *) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user