Thank you very much for your replies.
I will start using classic caches since i do not have to modify coherance
protocol for my work.

kind regards,
Armel
--
*JEATSA TOULEPI Armel*
Étudiant En Génie Informatique
Tel: +237 650771894 / 655296800


Le mer. 10 juil. 2019 à 18:11, Jason Lowe-Power <[email protected]> a
écrit :

> Hello, and welcome to the gem5 mailing list :).
>
> I suggest, at least as a first pass, using the classic caches, not Ruby.
> You can check out the Learning gem5 book (learning.gem5.org) to see
> examples of how to create different kinds of systems that don't necessarily
> match what's in se.py. The classic caches have an option to be "mostly
> inclusive" and "mostly exclusive" which might do what you need.
>
> I don't know if anyone has tried to have separate L2 instruction and data
> caches. However, this might "just work" with the classic caches assuming
> you have separate instruction and data busses (this should be possible). I
> suggest drawing the system you want to simulate on paper, then trying to
> create the configuration in gem5.
>
> If you want to investigate modifying the cache coherence protocol, or your
> investigation depends on high-fidelity modeling of the on chip network,
> then you should use Ruby. In this case, you'll probably have to write a new
> coherence protocol. You might be able to use other coherence protocols
> (e.g., MESI_Two_Level) as a starting point, or you might have to develop a
> new one from scratch (See Part 3 of Learning gem5 for details).
>
> Cheers,
> Jason
>
>
>
> On Wed, Jul 10, 2019 at 9:41 AM Armel Jeatsa <[email protected]>
> wrote:
>
>> Hello,
>> I am relatively new in gem5 simulator, i have to design a multiprocessor
>> architecture with two levels of caches composed of:
>>
>>    - At level 1: the usual L1i and L1d caches
>>    - At level 2 (shared by all processors): L2i and L2d caches, L2i
>>    inclusive with L1i, and L2d non-inclusive with L1d.
>>
>> What is the best solution? Use *Ruby *and* Slicc*, or just *Python* and
>> *C++*. How should I proceed in this case?
>> I ask this question because the *System* object in gem5 seems to only
>> accept an L2 bus.
>> Thank you in advance.
>> --
>> *JEATSA TOULEPI Armel*
>> Étudiant En Génie Informatique
>> Tel: +237 650771894 / 655296800
>> _______________________________________________
>> gem5-users mailing list
>> [email protected]
>> http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
>
> _______________________________________________
> gem5-users mailing list
> [email protected]
> http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
_______________________________________________
gem5-users mailing list
[email protected]
http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users

Reply via email to