Hi Martin, thanks for yours tips, I am using the Uboot for the yse5250. It boot fine, but when I am loading the genode binary(elf), it stays loading the system and doesnt show nothing on the serial console.
best regards, waldo El 22/01/15 a las 07:07, Martin Stein escribió: > On 22.01.2015 13:03, Martin Stein wrote: >> My Exynos 5250 manual says that >> uart0_base is 0x12C00000 and uart1_base is 0x12C10000 while uart0/1_clk >> should be the same as uart3_clk but both depend on the configuration > I mean "... same as uart2_clk ..." (the clock Genode uses currently) not > uart3_clk. > > ------------------------------------------------------------------------------ > New Year. New Location. New Benefits. New Data Center in Ashburn, VA. > GigeNET is offering a free month of service with a new server in Ashburn. > Choose from 2 high performing configs, both with 100TB of bandwidth. > Higher redundancy.Lower latency.Increased capacity.Completely compliant. > http://p.sf.net/sfu/gigenet > _______________________________________________ > genode-main mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/genode-main ------------------------------------------------------------------------------ New Year. New Location. New Benefits. New Data Center in Ashburn, VA. GigeNET is offering a free month of service with a new server in Ashburn. Choose from 2 high performing configs, both with 100TB of bandwidth. Higher redundancy.Lower latency.Increased capacity.Completely compliant. http://p.sf.net/sfu/gigenet _______________________________________________ genode-main mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/genode-main
