Hello! On 13:09 Mon 09 Jun, Hamilton Coutinho wrote: > On Sat, Jun 07, 2003 at 08:53:58PM -0400, Brett I. Holcomb wrote: > > > > I built a test kernel with i2c /proc option and that worked. However, to run > > sensors-detect I need the /dev option so I went back to menuconfig and > > checked it. I did make dep && make clean bzImage modules modules_install > > > > and got the errors shown below (these are from bug 10629 - I have > > 2.4.20-xfs-r3). Bugzilla lists this and the comment from Brandon is this is > > not a bug - we have to insure the deps we build this agains are the same we > > build the kernel with. Okay - how do I do that??? > > > > This kernel is the same one I've been running with for a couple of weeks, > > same /usr/src/linux tree. I built the kernel with the /proc i2c option with > > no problem - booted it and it worked - so I just went back and added the /dev > > option. Now it's broken. I tried running make mrproper, restoring my > > .config and running the make dep && .... command. I also tried make clean. > > None of that works. I even did depmod -a before building these. > > > > Any ideas on how to get the modules to "insure my deps" are proper? > > > > Thanks. > > > > depmod: i2c_bit_del_bus_R88f4afaf > > depmod: i2c_bit_add_bus_R933524db > > depmod: *** Unresolved symbols in > > /lib/modules/2.4.19-gentoo-r10/misc/i2c-i810.o > > depmod: i2c_bit_del_bus_R88f4afaf > > depmod: i2c_bit_add_bus_R933524db > > depmod: *** Unresolved symbols in > > /lib/modules/2.4.19-gentoo-r10/misc/i2c-savage > > 4.o > > depmod: i2c_bit_del_bus_R88f4afaf > > depmod: i2c_bit_add_bus_R933524db > > depmod: *** Unresolved symbols in > > /lib/modules/2.4.19-gentoo-r10/misc/i2c-via.o > > depmod: i2c_bit_del_bus_R88f4afaf > > depmod: i2c_bit_add_bus_R933524db > > depmod: *** Unresolved symbols in > > /lib/modules/2.4.19-gentoo-r10/misc/i2c-voodoo > > 3.o > > depmod: i2c_bit_del_bus_R88f4afaf > > depmod: i2c_bit_add_bus_R933524db > > > > Hello Brett, > > The functions i2c_bit_(add|del)_bus() are only available if you compile > your kernel with CONFIG_I2C_ALGOBIT. Check your .config file. > > If you keep getting unresolved symbols you should need to run 'modprobe > i2c-algo-bit' before running sensors-detect. > > Regards,
It's not really good idea, but when I got the same problems, I simply deleted all that modules (I got unresolved symbols in the same modules). Seems, it's because I don't have support for vodoo, i810 and Co enabled in kernel. And it works perfectly all last month. Best regards, Andrew. -- [EMAIL PROTECTED] mailing list