On Fri, Jul 25, 2003 at 03:18:59PM +0000, Rich Smith wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > On Friday 25 Jul 2003 1:50 pm, William Hubbs wrote: > > All, > > > > I have 2 network cards in this pc that seem to work fine under the 2.4 > > series kernel with the tulip driver. However, I can't seem to get them to > > respond under the 2.6.0-test1 kernel with the tulip driver. > > When you say they don't respons what do you mean ? Do the modules load without > error and they just dont bind to an interface. Or do the modules not even > load, or have you compiled the drivers into the kernel ?? > > If you give a bit more info it will be easier to try and help :)
Hi Rich and all, The driver is compiled into the kernel. It doesn't want to bind to an interface. Right now I am not running that kernel since I am accessing the machine via ssh, but when I get back home in a few hours I will work with it more. Below is the output from lspci -vv. Does this help identify the card? Should I be using the tulip driver? 00:00.0 Host bridge: ALi Corporation M1621 (rev 05) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort+ >SERR- <PERR- Latency: 0 Region 0: Memory at e0000000 (32-bit, prefetchable) [size=64M] Capabilities: [b0] AGP version 1.0 Status: RQ=32 SBA+ 64bit- FW- Rate=x1,x2 Command: RQ=0 SBA- AGP- 64bit- FW- Rate=x1 00:01.0 PCI bridge: ALi Corporation PCI to AGP Controller (rev 01) (prog-if 00 [Normal decode]) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0 Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 I/O behind bridge: 0000c000-0000cfff Memory behind bridge: d7d00000-d7dfffff Prefetchable memory behind bridge: d7b00000-d7bfffff BridgeCtl: Parity+ SERR+ NoISA+ VGA- MAbort- >Reset- FastB2B- 00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV] (rev b4) Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort+ <MAbort+ >SERR- <PERR- Latency: 0 00:0e.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20) Subsystem: Lite-On Communications Inc LNE100TX Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64 Interrupt: pin A routed to IRQ 12 Region 0: I/O ports at dc00 [size=256] Region 1: Memory at dbfefe00 (32-bit, non-prefetchable) [size=256] Expansion ROM at dbf40000 [disabled] [size=256K] 00:0f.0 IDE interface: ALi Corporation M5229 IDE (rev 20) (prog-if fa) Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (500ns min, 1000ns max) Interrupt: pin A routed to IRQ 14 Region 4: I/O ports at ffa0 [size=16] 00:10.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20) Subsystem: Lite-On Communications Inc LNE100TX Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64 Interrupt: pin A routed to IRQ 10 Region 0: I/O ports at de00 [size=256] Region 1: Memory at dbfeff00 (32-bit, non-prefetchable) [size=256] Expansion ROM at dbf80000 [disabled] [size=256K] 00:12.0 VGA compatible controller: S3 Inc. 86c764/765 [Trio32/64/64V+] (rev 54) (prog-if 00 [VGA]) Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Interrupt: pin A routed to IRQ 0 Region 0: Memory at dc000000 (32-bit, non-prefetchable) [size=64M] Expansion ROM at dbff0000 [disabled] [size=64K] Thanks, William -- [EMAIL PROTECTED] mailing list