Check the install instructions about setting up the
net.eth0 file. You need to set up the file with your
addresses and add it to the default runlevel.
On Tue, 29 Jul 2003 12:05:06 -0500
"Joe" <[EMAIL PROTECTED]> wrote:
Hello,
I am in the process of installing Gentoo on my
laptop (HP ze5185) and I=
have a networking question. I had a great network
connection with the l=
iveCD, but now my network card isn't recognized /
installed.
When I do an 'ifconfig' all I see is the lo setting,
not an eth0. At f=
irst I thought that this was because I had compiled the
wrong network dri=
vers in the kernel, so I went back and changed it to the
National Semicon=
ductor one listed on the kernel config screen (the
network card is Nation=
al Semiconductor Corporation DP83815 (MacPhyter) Ethernet
Controller. th=
is is internal - not a pcmcia card). However after all
this I am still u=
nable to connect to the internet. Does anyone know what
I might be doing=
wrong? Thanks for any and all help!
- Joe :)
--
[EMAIL PROTECTED] mailing list
