J. Roeleveld <jo...@antarean.org> [15-07-29 16:38]: > On Wednesday, July 29, 2015 05:18:25 AM meino.cra...@gmx.de wrote: > > Hi, > > > > the AP is now up and running ... but the the transfer rates are only > > about 80 Kb/sec (conky). > > > > I use an Atheros based USB wifi dongle, create_ap for setup and the > > internet connection goes via my PC. There are no other transfers > > running (check with wireshark), beside occassional dns and pop3 > > communications (very low data amounts) and the PC is nearly > > without load (ok...I am typing this email on it, but....;) > > > > Any way to push this up...? > > > > Best regards > > Meino > > Which WIFI type are you using? > Which USB-type? (USB-1 is dead slow, for instance) > > Is this speed between both machines? Or to the internet? > > -- > Joost >
Hi Joost, I fired up create_ip like this (just for testing and haveing at least ONE experienced succes with this Wifi stuff...): create_ap wlan0 eth1 <name> <pass> How can I check for the type of WIFI after the connection has been established? USB is USB 2.0 The speed is measured by conky, which reads the transfer rate at eth0. At that tome, the tablet was getting a greater piece of tar archive (LInux for Android) and no other traffic other than this was there. The DSL was by far not saturated. So physically it is the speed of the internet but logically it is nearly identical to what happens at the Wifi interface (I think). I will check for an app which displays the speed measured on the tablets interface... Best regards, Meino
