Hi,
I am attempting to create a simple airfoil model with specified surface
point locations. The script is attached.
The script first creates the airfoil surface as a spline, and then the
outer analysis boundary. Then, the surface is specified using the outer line
loop followed by the inner line loop to designate the hole.
The problem is that this is not creating a consistent planar surface,
which leads to failure of the meshing procedure.
It is likely that I am making inappropriate use of one of the functions,
but I am unable to figure that out. I would appreciate if someone could point
it out for me.
Thanks,
Manav
naca64a010.geo
Description: Binary data
_______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
