Thanks! It works! Manav
On Feb 5, 2013, at 9:55 PM, Christophe Geuzaine <[email protected]> wrote: > > On 05 Feb 2013, at 17:06, Manav Bhatia <[email protected]> wrote: > >> Hi, >> >> I am attempting to create a simple airfoil model with specified surface >> point locations. The script is attached. >> >> The script first creates the airfoil surface as a spline, and then the >> outer analysis boundary. Then, the surface is specified using the outer line >> loop followed by the inner line loop to designate the hole. >> >> The problem is that this is not creating a consistent planar surface, >> which leads to failure of the meshing procedure. >> >> It is likely that I am making inappropriate use of one of the functions, >> but I am unable to figure that out. I would appreciate if someone could >> point it out for me. >> > > Hi Manav - You should remove the duplicate point at the trailing edge, e.g. > by adding "Coherence;" after the Spline creation: see the attached file. > > <naca64a010.geo> >> Thanks, >> Manav >> >> <naca64a010.geo>_______________________________________________ >> gmsh mailing list >> [email protected] >> http://www.geuz.org/mailman/listinfo/gmsh > > -- > Prof. Christophe Geuzaine > University of Liege, Electrical Engineering and Computer Science > http://www.montefiore.ulg.ac.be/~geuzaine > > > _______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
