On 11/11/13 5:04 AM, guozhicheng222 wrote:
Hi
I am confusing with the output file (.log) about the sample frequency
(frames) in my simulation. The average information in .log file is
'Statistics over 300001 steps using 3001 frames' where nstxout =4000 and
nstlog =4000. While, 'Statistics over 300001 steps using 20001 frames',
appeared in .log file, where nstxout =15 and nstlog =15. In my opinion, the
former sample frequency should be 75 frames rather than 3001 frames and the
latter is right. I want to know how can I control the sample frequency,
arbitrarily.
Check to make sure you set nstlog correctly in the first run. Look for the
value in the .log file itself. It is highly unlikely that something so
fundamental and simple is being executed incorrectly in one run, but correctly
in another.
-Justin
--
==================================================
Justin A. Lemkul, Ph.D.
Postdoctoral Fellow
Department of Pharmaceutical Sciences
School of Pharmacy
Health Sciences Facility II, Room 601
University of Maryland, Baltimore
20 Penn St.
Baltimore, MD 21201
jalem...@outerbanks.umaryland.edu | (410) 706-7441
==================================================
--
gmx-users mailing list gmx-users@gromacs.org
http://lists.gromacs.org/mailman/listinfo/gmx-users
* Please search the archive at
http://www.gromacs.org/Support/Mailing_Lists/Search before posting!
* Please don't post (un)subscribe requests to the list. Use the
www interface or send it to gmx-users-requ...@gromacs.org.
* Can't post? Read http://www.gromacs.org/Support/Mailing_Lists