On Friday 26 October 2007 23:27:47 Glynn Clements wrote: > Martin Wegmann wrote: > > > run make distclean before re-compilation... > > > > I did run make distclean before svn update;.configure;make;make install > > "cvs update", right? > > > but is it normal that > > ... > > cvs server: Updating grass6/visualization/xganim > > cvs server: Updating grass6/visualization/xganim/bitmaps > > cvs server: Updating grass6/visualization/ximgview > > > > appears also when I execute 'cvs update -dP grass6' a second time? > > Yes. FWIW, I normally use: > > cvs update 2>&1 | fgrep -v 'cvs server: Updating ' > > so that important messages aren't lost amongst the noise. > > > I thought it just tells me that no updates are available after the second > > try. > > > > Perhaps it is a local problem, I might give it a try to update in a fresh > > folder and copy all my modules into this new grass6 folder. > > The fact that the --help output says: > > > > output Name for output raster3d map > > indicates that the r.to.vect module was compiled with a different > version of gis.h than was used for libgis. > > This usually means that one of the two has been recompiled after an > update while the other hasn't, but it can also occur if compilation > uses an installed version of gis.h rather than the local copy. > > It's also conceivable that it could end up using an old version of > libgis via GDAL, although I have no confirmation of this happening in > practice.
I created a new folder and redid the whole procedure - now it works again - no idea where I messed up the cvs update. Martin _______________________________________________ grassuser mailing list grassuser@grass.itc.it http://grass.itc.it/mailman/listinfo/grassuser