ah... ok... use: v.build map=mapname
then retry with v.digit over the same map.... Il giorno gio, 01/11/2007 alle 23.24 +0100, [EMAIL PROTECTED] ha scritto: > Hola Isabel and all, > > Isabel Alfaro Cardozo ha escrito: > > What does it mean when it sais > > > > Fallo de segmentación (core dumped) > > > > once I run the v.digit command it makes a new map and then it shows this > > mistake please if some one could help me!.. > > It means that an error occurred while v.digit was running. Usually, > after that error the vector map is not created correctly. That's why > you get those other warnings below. > > Maybe, someone in the list could help and you if you explain what you > tried with v.digit. > > > i also tried to use r.to.vect but i got this message > > > > r.to.vect > > WARNING: coor files of vector '[EMAIL PROTECTED]' is larger than it > > should be (14 bytes excess). > > WARNING: Cannot display areas, topology not available > > Un saludo, > Roberto. > > > > > _______________________________________________ > grassuser mailing list > grassuser@grass.itc.it > http://grass.itc.it/mailman/listinfo/grassuser > -- Ti prego di cercare di non inviarmi files .doc, .xls, .ppt, .dwg. Preferisco formati liberi. Please try to avoid to send me .doc, .xls, .ppt, .dwg files. I prefer free formats. http://it.wikipedia.org/wiki/Formato_aperto http://en.wikipedia.org/wiki/Open_format Ivan Marchesini Department of Civil and Environmental Engineering University of Perugia Via G. Duranti 93/a 06125 Perugia (Italy) Socio fondatore GFOSS "Geospatial Free and Open Source Software" http://www.gfoss.it e-mail: [EMAIL PROTECTED] [EMAIL PROTECTED] tel: +39(0)755853760 fax (university): +39(0)755853756 fax (home): +39(0)5782830887 jabber: [EMAIL PROTECTED] _______________________________________________ grassuser mailing list grassuser@grass.itc.it http://grass.itc.it/mailman/listinfo/grassuser
