Shannon,
The SAPI and ECI versions of Eloquence do not co-exist. It is because
you have the older SAPI version that you are not seeing your ECI
engines. See our knowledge base article on this when we released WE 7.0
with the ECI version.
http://www.gwmicro.com/Support/Knowledge_Base/?kbnumber=GWKB1088
Regards,
Doug
shannon wrote:
Marvin,
I had installed the patch and didn't notice any real change but then I
changed back to the SAPI eloquence and stopped my pausing problems.
Doug had written to me asking if I could call him and demonstrate the
pausing problem during a read to end. He said that the patch was to
have addressed that particular problem. I was going to switch back to
the Eloquence voice and call him this morning but my Eloquence voices
are gone.
I am not running the script you are talking about and in fact turned
off any that I did have running and they didn't come back.
Do you have any other ideas as to where they might have gone?
I had them last week and now I don't. Shrug
Maybe if I get them back the pause problem will have also gone away
too. Smile
Can't imagine where they went?
Thanks for any thoughts
Shannon
----- Original Message -----
*From:* Marvin Commerford <mailto:[email protected]>
*To:* [email protected] <mailto:[email protected]>
*Sent:* Saturday, February 06, 2010 12:06 PM
*Subject:* Solution to Eloquence voices not found
Good morning. I remember messages about the Eloquence voices not
being found after patch installation. I ran into this earlier
this morning on my old XP box. The voice rotor script was
installed on this machine with Eloquence Reed in the list. Voice
rotor didn't find the voice. I checked the synth list in WE and
there were no voices listed under Eloquence. I stopped the voice
rotor script and like magic the list of Eloquence voices returned
to WE's synthesizer list. I restarted the script and again the
problem occurred. I tried to remove Reed from its list and put it
bak in. It's a no go on this box. The Voice rotor script is the
newest version. I may try to remove it and reinstall it from
scratch but it seems that this script just does not like something
with this particular machine. In summary, you have the Eloquence
voices when you install the patch. If you don't see them stop or
remove Voice rotor and you'll see them. Good luck.
If you reply to this message it will be delivered to the original sender
only. If your reply would benefit others on the list and your message is
related to GW Micro, then please consider sending your message to
[email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can
manage your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
