I too got an error when trying to send a window-eyes error to GW. It said "invalid handle"; how about yours? It's very helpful to them if you can remember any of the error text.
Chip -----Original Message----- From: Tony_C [mailto:[email protected]] Sent: Saturday, November 26, 2011 4:49 PM To: Pat Ferguson; [email protected] Subject: Re: Problems with Window-Eyes 7.5.2 Hi Pat, I had the same problem a few times since I upgraded to 7.5.2. Two or three times when in WLM WE just quit and never came back until I rebooted. Once when I rebooted the WE error report came up and when I clicked on send report I got the message that there was and error in the error reporting. LOL!! Tony -----Original Message----- From: Pat Ferguson Sent: Saturday, November 26, 2011 2:13 PM To: [email protected] Subject: Problems with Window-Eyes 7.5.2 Hi Everyone, I am experiencing more problems with Window-eyes 7.5.2 not speaking. It just stops talking when I go into my computer, and into a folder and I have to load Window-Eyes several times in order for it to get straightened out. It starts talking, and then it just stops talking and then it will start talking a little bit and then it will cut out when I alt-tab. I see some instability here. I was going to reboot my computer, but then it started talking again, so I didn't have to reboot. This is very frustrating when it starts cutting out like that. Any ideas are very much appreciated. Thanks. Pat Ferguson If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
