To clean my molds I periodically put them in water with soap and bring it to a boil. Then I set the pan somewhere to cool and once the paraffin hardens I take it off then rinse the molds with a lot of water, dry and spray with mold release. I don't need to do this too often but I like doing it in the winter so I can set the hot pan outside to cool Roberta Horner HTL/HT Penn State University Animal Diagnostic Lab
-----Original Message----- From: histonet-boun...@lists.utsouthwestern.edu [mailto:histonet-boun...@lists.utsouthwestern.edu] On Behalf Of Popp, Laurie A. Sent: Friday, May 22, 2009 4:17 PM To: histonet@lists.utsouthwestern.edu Subject: [Histonet] Cleaning embedding molds Happy Friday all and a long weekend too! I am in a research area where all tissue received is fixed, processed, and embedded as a general rule but we occasionally have blocks that require re-embedding. Today I was re-embedding very old blocks today and some of my pans have a brown sludge in the bottom of them that is probably degraded paraffin as the blocks were from 1970-1980 roughly. We don't normally have a way to clean our pans but this is something that is not going to just melt out and wipe up ( Very Sticky). Does anyone have any suggestion for cleaning? Thanks! Laurie Popp, BA HT ( ASCP) TACMA Shared Resources Mayo Clinic Rochester Laurie Popp, BA HT ASCP cm TACMA Shared Services _______________________________________________ Histonet mailing list Histonet@lists.utsouthwestern.edu http://lists.utsouthwestern.edu/mailman/listinfo/histonet _______________________________________________ Histonet mailing list Histonet@lists.utsouthwestern.edu http://lists.utsouthwestern.edu/mailman/listinfo/histonet