We haven't cleaned our molds for five years - if the blocks are cold enough after embedding, there is no problem removing the block.
-----Original Message----- From: histonet-boun...@lists.utsouthwestern.edu [mailto:histonet-boun...@lists.utsouthwestern.edu] On Behalf Of O'Donnell, Bill Sent: Monday, October 08, 2012 2:32 PM To: histonet@lists.utsouthwestern.edu Subject: [Histonet] Metal molds OK folks, I know I should be smarter than this and I haven't seen discussion on it lately.... Are people cleaning their metal embedding molds after evey embedding session? If not, how often do you clean them? Do you clean them at all? If you clean them, how do you do it? Thanks Bill William (Bill) O'Donnell, HT (ASCP) QIHC Senior Histologist Good Samaritan Hospital 10 East 31st Street Kearney, NE 68847 SERENITY is not freedom from the storm, but peace amid the storm. Cultivate it in PRAYER! This electronic mail and any attached documents are intended solely for the named addressee(s) and contain confidential information. If you are not an addressee, or responsible for delivering this email to an addressee, you have received this email in error and are notified that reading, copying, or disclosing this email is prohibited. If you received this email in error, immediately reply to the sender and delete the message completely from your computer system. _______________________________________________ Histonet mailing list Histonet@lists.utsouthwestern.edu http://lists.utsouthwestern.edu/mailman/listinfo/histonet _______________________________________________ Histonet mailing list Histonet@lists.utsouthwestern.edu http://lists.utsouthwestern.edu/mailman/listinfo/histonet
