message: 21 date: Tue, 19 Apr 2005 10:03:49 +0200 from: <[EMAIL PROTECTED]> subject: RE: [Hornlist] 3rd Valve Slide
Yes, cut the slide shank for some millimeters. Prof. Pizka has it right. Some elaboration though. Pull the slide to the point where it is getting stuck and mark the legs with a Sharpie or similar marker. Then cut just a bit past that (on the crook side of the mark) with as fine a saw blade as possible and as close to square as you can get it by hand. X-acto makes nice blades for this, available at your finer hobby stores. Deburr the tubing (very important) and slide the cut off pieces into the slide sleeves all the way in. This will keep the bore as consistent as possible. Take care, Stuart de Haro Stuart A. de Haro, Custom Horn Leadpipes, Brass Repair and Modification (217) 377-1462 [EMAIL PROTECTED] http://www.deharohorns.com __________________________________ Do you Yahoo!? Plan great trips with Yahoo! Travel: Now over 17,000 guides! http://travel.yahoo.com/p-travelguide _______________________________________________ post: horn@music.memphis.edu unsubscribe or set options at http://music.memphis.edu/mailman/options/horn/archive%40jab.org