On 7/11/07, Jesus Jr M Salvo <[EMAIL PROTECTED]> wrote: > On 11/07/07, Sanjay Arora <[EMAIL PROTECTED]> wrote: > > Hello all > > > > I just bought a multifunction device HP 2840. I have connected it > > through the network port giving it a static ip address on my private ip > > subnet 192.168.2000/24 FC6 updated till date had HPlip v. 1.7.2-3.fc6 > > installed. When I ran hp-setup, it stated that ppd file for the printer > > rot found. I assumed that the driver needed to be updated and since no > > rpm file was available, I used the source file of hplip.2.7.6 > > You only need at least 0.9.5 for that MFP ( 2840 ), according to this: > > http://hplip.sourceforge.net/supported_devices/color_laser_mfp.html > > So why did you not just use the RPMs for FC6, which was 1.7.2 as you said ? > As I said, during hp-setup it stated that it did not have the ppd file for the printer and I naturally assumed that I need to upgrade the driver. Didn't notice the minimum driver requirements at the page.
So if I install the rpm driver version 1.7.2 back, where do I get the ppd file for hp 2840? > FWIW, I just bought an HP Photosmart C3180, and everything worked out > of the box ( printer, scanning, card reader ), although only USB and > not JetDirect. Wish I had been that lucky ;-) With regards. Sanjay. ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ HPLIP-Help mailing list HPLIP-Help@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/hplip-help
